4O3A Signature – Antenna Genius Quick Start Guide
Pin-to-Port
is used by 4O3A manual controllers. Expected control signal is +12VDC. The pinout
table is found below.
GSD
protocol stands for Genius Series Device and is used for connecting the 4O3A Interface or
4O3A Station Genius to supply band data.
BCD Pinout
Pin-To-Port Pinout
Network Settings
AG expects a DHCP server on the network in order to obtain an IP address.
A static address can be set using the Windows app.
If no DHCP server is found on the network AG will assign itself a fallback address: 192.168.1.140
Windows App / Firmware Update
Download the latest version of the AG Windows App from our support page under Antenna
Genius:
https://4o3a.com/support/downloads
The latest firmware file is included in the app. Use the Firmware Upgrade option from the
configuration menu to upgrade your AG to the latest firmware.
WARNING:
Never use a wireless or remote connection to upgrade firmware on any 4O3A
device due to risks of bricking.
Please use a wired local ethernet connection instead.
Help and Support
You can reset the IP and Configuration settings at any time by setting the DIP7 to ON while
powering up. After the power up set DIP7 to OFF and power cycle again.
Read the complete AG User Guide on our support page under Antenna Genius:
https://4o3a.com/support/downloads/
Join our discussion board and meet our community on our forums:
Write to us directly to our support email:
