Aprisa FE Quick Start Guide 1.4.0 © 2017 4RF Limited. All rights reserved. This document is protected by copyright belonging to 4RF Limited and may
not be reproduced or republished in whole or part in any form without the prior written permission of 4RF Limited. While every precaution has been
taken in the preparation of this literature, 4RF Limited assumes no liability or errors and omissions, or from any damages resulting from use of this
information. The contents and any product specifications within it are subject to revision due to ongoing product improvements and may change
without notice. Aprisa and the 4RF logo are trademarks of 4RF Limited. All other marks are the property of their respective owners.
5. Setup the Aprisa FE radio
The Aprisa FE point-to-point radio end points are Local Radio and
Remote Radio.
Set the Ethernet Operating Mode required.
Set the Aprisa FE TX Frequency, RX Frequency, TX Power and Channel
Size to comply with your site license.
You can now configure the remaining terminal and link parameters and settings. Please refer to the Aprisa FE User Manual for detailed
instructions.
6. Monitor the Aprisa FE radio signal strength
When the link is installed, the radio signal strength can be monitored
on radios by setting the radio to Test Mode.
To enter Test Mode, press and hold the TEST button on the radio LED
panel until all the LEDs flash green (about 3 - 5 seconds).
In Test Mode, the LED Display panel presents a real time visual
display of the RSSI. This can be used to adjust the antenna for
optimum signal strength.
Note: The response time is variable and can be up to 5 seconds.
To exit Test Mode, press and hold the TEST button until all the LEDs
flash red (about 3 - 5seconds).
The OK, MODE and USB LEDs will be solid green and the TX and RX
LEDs will be solid or flash green if the link is operating correctly.
For more information, please refer to the Aprisa FE User Manual available from the 4RF website www.4rf.com/secure/ (login required).
Quick Start Guide
Aprisa FE Radio
Contents
Follow these steps to operate your Aprisa FE radio:
1.
Check the box contents
2.
Install the Aprisa FE radio and connect the protection earth
3.
Connect the Antenna and apply power to the Aprisa FE radio
4.
Connect to the Aprisa FE radio
5.
Setup the Aprisa FE radio
6.
Monitor the Aprisa FE radio signal strength
