Incorrect fitment/alignment of the Seat Cover can prevent the vehicle’s seat airbags from deploying correctly in the event of
The correct fitment and securing of the Seat Covers on the vehicle’s is essential in order for the airbag to work correctly.
an accident. In order for the Seat Covers to fit correctly please do as follows:
1.
These Canvas Style Seat Covers have the airbag seams on both the left and right hand
side which enables the Seat Covers to be fitted to either the driver’s or passenger’s seat.
2.
The driver’s and passenger’s Seat Cover must be fitted into the correct position with the
side seams of the Seat Cover covering the side airbag section of your vehicle’s seat.
3.
Ensure that you inspect your Seat Covers for movement and wear regularly. Seat Covers that have moved must be
repositioned immediately. Ideally the Seat Covers should be realigned and tightened if movement is noticeable. If you are
unable to reposition or tighten the Seat Cover due to the wear on them, they must be removed and replaced.
4.
Do not re-sew or interfere with any part of the Seat Cover including the side seam as the Seat Covers have been designed in
a way that allows the airbag to deploy through the Seat Cover in the event of an accident by splitting the side seam open.
5.
Do not attempt to alter the Seat Cover in any way; for example do not attempt to create your own hole in the Seat Cover for
an existing armrest your vehicle may have.
6.
Do not continue to use the Canvas Style Seat Covers if the airbag has been deployed. Immediately remove and disregard
any of these Seat Covers.
7.
In the event that the side seam splits do not attempt to repair this as it will hinder the correct operation of the Seat Cover.
Note
- The barcode label is created by a unique barcode system which uses a technique of measuring the accuracy of the sewing;
every set is given its own unique barcode number.
Safety Information
Fitting Instructions
Step 2 - Remove the barcode labels located on the inside of the driver’s and passenger’s Canvas Style Seat Cover and
Step 1 - Remove Head Rests if possible.
place on the registration form. (There are two labels per Seat Cover)
Step 3 - Fit the back section of the Seat Cover by sliding it over the top of the vehicle’s seats and gently pulling it down the
seat until it is a neat fit.
Step 4 - Push the touch tape through the space between the back and base sections of the vehicle’s seat. Move the seat
backs into a forward position; take the touch tape at the front and pass them through the rings at the back of the seat and
guide them back to match back up to the front.
Step 5 - Adjust the Seat Cover gradually from the top to the bottom pulling the fabric’s polyester on the side of the seat to
align the Seat Covers with the vehicle’s seats actual piping.
Step 6 - Finally, fit the Head Rest covers and replace the Head Rest if necessary.
Care Instructions
Manufacturer
IMPORTANT
• Cold hand wash only
• Drip dry in the shade
• Do not soak
• Do not iron
• Do not wring
• Do not bleach
• Do not tumble dry
• Do not dry clean
Motozone Auto Accessories, PO Box 5213, Mordialloc Vic 3195
Telephone: 1300 883 104
email: sales@4x4tough.com.au
Website: www.4x4tough.com.au
