5Core Pro Series, Operational Manual

Back Panel Controls & Features

Guideline to Operate the Amplifier

1.  Place the Amplier in dry and well ventilated place. Considerable heat is 

generated inside the amplier during continuous use, therefore do not block the 
air ventilation holes of the active amplier.

2.  Only good quality Low impedance microphones like 5 CORE 5CM-ND 780X, ND 

99X or ND series to be used to avoid / reduce feedback & howling. This will help 
obtaining satisfactory power output from Amplier without howling or feedback.

3.  It is advised to keep the master Control of the Amplier at’0’ position before 

switching ‘ON’ the Amplier & later may be moved to optimum position say ‘6 to 8’.

Safety Instructions

•  WATER AND MOISTURE:

 In order to prevent any re or shock hazard, do not 

expose this equipment to rain or moisture.

• 

POWER SOURCE:

 The equipment should be connected to a 220-240V 50/60Hz.

• 

POWER CORD PROTECTION:

 Do not cut, damage or modify the power cord 

supplied with the equipment, keep the power supply cord away from heaters and 
harmful chemicals. Do not place heavy objects on the power cord.

• 

Operation on Generator:

 When operating the Amplier on a generator, make 

sure it is switched ‘OFF’ till the generator voltage has stabilized and then only 
switch the amplier ‘ON’.

• 

VENTILATION:

 The amplier should be situated so that its location or position 

does not interfere with its proper ventilation, Also do not insert or drop anything 
into the ventilation holes.

• 

PREVENTION OF LOSS IN SPEAKER CABLES: 

Always use thick cables for low 

impedance speakers connections, Use of cable type 23/38 or thicker is 
recommended as heavy current ow through the cables.

• 

GROUNDING OR EARTHING:

 The equipment must be earthed properly before 

operating it to avoid electric shock. A wire from the earth terminal must be 
connected to either water pipe or to electrical earth for safe operation.

Page 3

Page 2

•  Provision for both AC and inbuilt DC 12V (Rechargeable) Battery Operation 

ensures continuity of program.

•  MIC-1 to MIC-2 are provided with individual Volume Control.
•  BASS, TREBLE & Echo controls provided for shaping tonal quality of music 

& speech as desired.

•  MASTER control permits adjustment of overall volume of program inputs.
•  Protection against wrong battery polarity-provided.
•  Audio output & input provision
•  Seperate tone control provided for volume/treble/bass/echo/mic/guitar.
•  Seperate tone control provided for Mic Treble and Mic Bass.
•  Inbuilt neodymium tweeter.
•  Wireless hand microphone & head microphone
•  Bluetooth module with recording feature.
  1.  VOLUME : Slide shortly to volume level+ & volume level-.
  2.  MODE : To select All Modes (AUX/       /MMC/Bluetooth). 
  4.  PREVIOUS : Press shortly to select the previous song in        /MMC 

mode.

  5.  PLAY/PAUSE : Press shortly to Play/Pause the song in        /MMC mode. 

Press for 3 second to auto scanning in FM mode.

  6.  NEXT : Press shortly to select the next song in        /MMC mode. 
  Note: Due to continuous upgradation, specifications and features may 

change without intimation of prior notice.

Speaker and Tweeter used in Amplifier

FR 15120

Frame: MS, 15”
Cone: Paper body with cotton edge
Impedance: 4

W

Max Power: 850PMPO
Magnet: 120X57X20
Voice Coil: 1.5” Voice coil with Aluminium heat sink

Neodymium magnet

ND-T01