- 7 -
Setting up the document shredder:
1. Securely mount the document shredder on the waste basket included. In the process, ensure
that you do not catch your fingers between the top edge of the waste basket and the shredder.
The top part is quite heavy.
Note: there is an additional box inside the packaged used as a CD shreds bin, please hang CD
waste box to the ribs on backside wall of the waste basket
Operation
Please check the Voltage of your shredder carefully before using. Then plug in and
press the power switch to “I” position.
Set Control Switch to "I" - Stand by Mode
Ensure the sheets to shred does not exceed the shredders rated sheet capacity.
PAPER shredding: Feed papers into feed entry - shredder will Start automatically and
Stop automatically once shredding is finished.
CD/DVD shredding: Pushing the operation switch button to ˝R˝ position, feed only one
(1) CD/DVD Disc into CD Entry to Start CD shredding, Then set the operation switch
back to ˝O˝ after finishing CD/DVD shredding.
CREDIT CARD shredding: Feed only one (1) Credit Card into Paper Entry where the
card has to touch the sensor. Shredder will Start shredding automatically and Stop
Automatically once shredding is complete.
Press the operation button to “O” position to finish operation.
Set the power switch to “O” position to cut off the power
Protection against paper jams and overloading:
The paper shredder is equipped with a motor overload protection guard. The normal work cycle for the
shredding operation is 2 minutes with a maximum load at last, so the machine should have a break for 35
minutes. Under the following conditions, the power supply will be interrupted to the shredder:
1. Continual operation of the document shredder with maximum capacity for a prolonged period of
time, e.g. longer than 2 minutes without interruption.
2. Overloading the shredding capacity e.g. adding more than 12 sheets of paper (80g) in one
operation or in the event that the paper is not inserted length-wise into the feed slot and inserted
in lateral direction.
Under the above-mentioned conditions, the automatic overload guard of the motor is triggered, where
upon the current feed to the device is interrupted. In such a case, please take the following steps:
1. Unplug the power cord from the AC outlet and wait at least 35 minutes for the overload
protection to reset .Tear or cut off any excess paper from the top of the shredder.
2. Reconnect the mains plug to the AC socket and set the switch to the REV position. The excess
paper will be ejected again. Disconnect the mains plug again and then remove the remaining
paper from the shredding blades. Afterwards, set the switch back to the AUTO position. If
necessary, repeat the steps.
