Elevator in UP position
Elevator may bind slightly in DOWN
position
Trim a small piece (1/8”) of the elevator
at an angle to free the elevator.
Attach the elevator using Dubro hinge
tape or with a similar product once free
motion has been achieved.
Motor Installation
Installing the motor is very simple using
the stick mount you previously installed.
It may be necessary to trim the stick
mount during this process. In addition,
it may be necessary to trim back portions
of the foam in the tail. It is important to
get the motor as far forward as possible.
You do not want to just mount the motor
way out on the stick. Any foam that is
removed must be from the bottom or
sides.
1. Dry fit your motor and determine if
any stick or foam will need to be
trimmed.
Underside of tail was trimmed to
accommodate motor.
Marking the stick to be trimmed with a
hand saw.