60
User Manual v1.3
3.4.2.2 IP
Filter
Use IP Filter to deny LAN IP addresses from accessing the Internet. You can deny specific
port numbers or all ports for the specific IP address.
1. Enable IP Filter:
Check enable or disable to apply IP Filter function.
2. Enable Log:
All packets between WAN and LAN will be logged.
3. Source:
To specify the appropriate IP address / mask and enter the source port
number.
4. Destination:
Allows you to set the destination address / mask to which this rule should
apply and enter the source port number.
5. In/Out:
Select inbound or outbound ACL (Access Control List) rules, you can control
(allow or deny) incoming or external network access to computers on your LAN.
6. Protocol:
This option allows you to select protocol type. Available settings are TCP,
UDP and ICMP.
7. Listen:
To check if a computer is on the Internet. It sends ping packets and listens for
replies from the specific host.
8. Time Ranges:
Apply IP filter by setting time ranges.
9. Action:
Select Deny, the IP filter will deny for above time range, otherwise, to allow IP
filter in above time.
10. Side:
Set the IP filter from LAN or WAN, or you may select both side.
11. Add, Apply & Cancel:
After finish above setting, click
Add
button to create the new ACL rule. Click on
Apply
button to add the settings into the list table. Click on
Cancel
button to clear the settings on
this page.
Summary of Contents for PE-8074
