18
MC258-2 Device Control with DeltaServer : User Guide
© 2023 7thSense
Art-Net/DMX Control
Input Subnet
The IP subnet being listened from
Number of frames to record
This is the number of Art-Net frames to record (not movie frames).
ArtNet Input Enabled
This is essentially the same checkbox that can be found in
Config
>
Preferences
>
ArtNet & DMX
to enable Art-Net input.
Loop playback at file end
Plays the Art-Net recording continuously until playback is cancelled.
Set Save file
Set the file to record to. When this is set, and Input is enabled, the Record button becomes
available.
Set Playback File
The file to be read from, in order to playback Art-Net. Once this is set and Art-Net input is
disabled, the PlayBack button becomes available.
External Controls
(listed under ‘Recording Commands’): ARTNET_RECORD.
With this control you can set any of the Art-Net recording parameters. Use Recording Mode to change
whether you’re recording, playing back or neither. Note, you will need to ensure you are in the correct
Art-Net input/output mode, See ARTNET external control (listed under ‘Media Commands’).
Example:
artnet_record StartChan=1 EndChan=13 Universe=3 Subnet=2 ByteRange=2 InputIP=192.168.71.10
InputIPSubnet=255.255.255.0 NumberFramesToRecord=80 SaveFile=C:\Movies\Record\art_test.txt
PlayBackFile=C:\Movies\Record\artnetrec.txt RecordingMode=Idle LoopPlayback=true
Note
: Save and PlayBack files are .txt files.
Using Serial Events for Device Control
Delta has a range of pre-built serial events for to allow sending out serial codes to external devices at
set times on the timeline and additionally, you can write more complex serial commands within a
Delta Sequence, for example to enable real-time interaction. This document demonstrates how to set
up a projector using serial communications and trigger serial events using both direct and sequence
methods.
Summary of Contents for DeltaServer
Page 1: ...Delta Media Server Device Control with DeltaServer MC258 2 User Guide ...
Page 57: ......
Page 58: ......
Page 59: ......
