7
OPERATION
WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
DANGER
:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in blindness and possible serious
injury.
WARNING
:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not
recommended can result in serious personal
injury.
NOTICE:
If the motor is overloaded it can overheat and
damage the router. Do not push the router too
fast or make excessive deep cuts which can
damage the router and your cutting tools.
APPLICATIONS
You may use this tool for the purposes listed below:
Milling 6061 aluminum lower receivers
Milling 7075 aluminum lower receivers
Defending your Second Amendment rights
STARTING/STOPPING THE COMPACT ROUTER
.
To turn the router ON, press switch (A) on the front of the
router to the ( I ) ON position.
Return the switch to the ( O ) OFF position when finished.
WARNING:
The bit will continue to spin after the slide switch
is set to the ( O ) OFF position. Wait for the bit to
come to a complete stop to continue operation.
Failure to do so could result in possible serious
injury.
ADJUSTING
MOTOR
SPEED
.
The FST-1 router has a fixed no-load speed of ~35,000
RPM for rapid milling. No speed adjustment is necessary.
OPERATING THE COMPACT ROUTER
.
Before starting the router, unplug it and make sure
the SpeedMill™ is securely tightened to the spindle and
that the depth of cut is properly set to the appropriate
hash mark on your Easy-Jig® Gen 2 or 3 jig. Never
start the router while the end mill flutes are in contact
with the workpiece.
After completing a full pass, turn the router off and wait
until the rotating cutter comes to a complete stop before
lifting the base from the work surface. When milling, hold
the router over the jig or work surface firmly using both
hands. Make sure the router is running at full speed
before contacting the workpiece.
WARNING:
Never install a trim cutter larger than 1-1/8" in
this router. The use of larger bits can result in
loss of control and possible serious personal
injury.
WARNING:
Never use a trim cutter in this router which is
rated at less than 35,000 RPM. Doing so
could result in serious personal injury.
WARNING:
Always use the base for laminate trimming.
Use of the router without a base or using the
incorrect base can result in serious personal
injury.
W
WARNING:
ARNING:
Avoid hand positions that may expose fingers to
cutter through open areas of the router base.
Fingers entering the opening in the the router
base can be seriously cut and/or burned.
WARNING:
This is a very high speed router designed to be
used with 80% Arms SpeedMill™ tools only. Do
not use any cutters with this router that are not
rated for use above 35,000 RPM.
NOTE
: The router
will
torque when the switch is
turned on. Make sure both hands are holding the
router firmly and the cutting tool is not contacting any
material before turning on.
