150Mbps Wireless ADSL2+ Router
User Manual
33
default SSID.
SSID Broadcasting
: You can select “enable” or “disable” to enable or disable the broadcast
SSID function, if the setting of the field is disable, wireless client can not obtain this SSID to
login in, the user have to input the SSID value manually.
Channel Bandwidth
: This switch allows you to set Router's wireless bandwidth modes:
a)
20MHz
: Setting the Router to this mode only allows 20MHz operation. This mode is
compatible with 802.11n, 802.11g and 802.11bgear, but will limit Wireless N routers'
bandwidth by half the rate.
b)
40MHz
: Setting the Router to this mode allows only 40MHz operation. This mode is
compatible only with router, draft 802.11n compliant devices. It may affect legacy
802.11b/g devices. Use only when you have a pure router, draft 802.11n wireless
network.
Control Sideband
: It controls your wireless router use the higher or lower channel to tranfer
related datas while it working on 40Mhz mode.
Channel
: You can set the working channel from 1 to 14 manually to avoid interference.
4.5.2. Security
Choose "
Security Setup
Access Control
", you can see the Security screen shown below.
The item allows you to encrypt your wireless communication, and you can also protect your
wireless network from unauthorized user access.
Authentication Type:
There supplies "
None
", "
WEP
", "
WPA-PASK
", "
WPA2-PSK
" and
"
WPA/WPA2-PSK
" five different encryption modes. "
None
" means do not encrypt wireless
data.
WEP:
There are two basic levels of WEP encryption, 64 bits and 128 bits, the more bits
password have, the better security wireless network is, at the same time the speed of
wireless is more slower. If you select WEP to encrypt your data, choose the bits of
