9
Introduction
Congratulations on purchasing your new 450 Amp Jump
Starter. Read this Instruction Manual and follow the
instructions carefully before using this unit.
Charging / recharging
Lead-acid batteries require routine maintenance to ensure
a full charge and long battery life. All batteries lose energy
from self-discharge over time and more rapidly at higher
temperatures. Therefore, batteries need periodic charging to
replace energy lost through self-discharge. When the unit is
not in frequent use, manufacturer recommends the battery
be recharged at least every 60 days.
WARNING: Never attempt to use the AC and DC
charging methods at the same time
.
Notes:
This unit is delivered in a partially charged state
– you must fully charge it before using it for the first time.
Initial AC charge should be for 36 hours.
Recharging battery after each use will prolong battery
life; frequent heavy discharges between recharges and/or
overcharging will reduce battery life. The battery can be
recharged using either the 240 Vac charger plug pack or the
DC charging adapter.
Make sure all other unit functions are turned off during
recharging, as this can slow the recharging process.
Charging/Recharging Using the 240 Volt AC Charger
1. Lift the AC to DC Input Socket cover located on the
back of the unit and connect the plug from the 240 Vac
charger plug pack. Plug 240 Vac charger plug pack into a
standard 240 Vac power point and turn on.
2. Charge until two red and one green LED Battery Status
Indicators light.
3. Once fully charged, turn off the 240 Vac charger plug
pack at the power point and then remove the plug from
the rear socket of the appliance. Replace the socket
cover.
Note:
The unit cannot be overcharged using this method.
12 Volt DC Charging Method
Charging the unit from an external 12 Vdc power source
requires the use of the 12 Vdc charging adapter. This
adapter has a male DC connector at each end.
1. Insert the gold-tipped 12 Vdc Charging Adapter plug into
the vehicle’s 12 Vdc accessory outlet.
2. Insert the silver-tipped end plug into the 12 Vdc
accessory outlet on the front panel of the unit.
3. Charge the unit until the green FULL indicator lights when
the Battery Power Level Button is pressed (with the adapter
unplugged from the unit). DO NOT CHARGE MORE THAN
6 HOURS MAXIMUM USING THIS METHOD.
4. When charging is complete, turn the ignition switch to the
off position and remove the charging cord and store in a
safe place.
Notes:
Some vehicles require that the ignition be switched
to the accessory outlet position in order to power the
accessory outlet.
Do not leave the unit unattended when charging using
this method.
Jump starter
This Jump-Starter is equipped with an On/Off Power Switch.
Once the connections are properly made, turn the switch on
to jump-start the vehicle.
1. Turn off vehicle ignition and all accessories (radio, A/C,
lights, connected cell phone chargers, etc.). Place vehicle
in “park” and set the emergency brake.
2. Make sure the Jump-Starter Power Switch is turned to off.
3. Remove jumper clamps from clamp tabs. Connect the
red clamp first, then the black clamp.
