Step 7 – Testing Basic S4 Operations
If S4 is being installed at an installation shop,
please
take note:
Each S4 has it’s own phone number. The
Owner is provided this number when they register with the
911SafeTrack Service.
The Owner needs to tell the
Installer the S4 number.
Turn On vehicle ignition and confirm (if visable) that the
green LED is On and the red LED starts to blink. Note:
The red LED may take a few minutes to start blinking.
Installer uses any cell phone to send S4 a text message
12345 gps
(note space after PIN) and checks to verify
that the S4 replies with a location text message.
Installer uses any phone to call S4 and listens to the
message, presses ‘
1
’, and listens to further message.
Then Installer presses ‘
9
’ and S4 makes a 3-party
conference call to a special 911SafeTrack
test number
and the Installer is able to hear a response confirming
success. S4 will send a confirming text message.
Do not press #, since S4 will call 911.
Installer can then send S4 a text message:
12345
at*user=0,InstallerMobileNumber,1
(note space after
PIN).
S4 will respond to the Installer with the message: OK.
911SafeTrack.com
13
