11
SPI & SPP MANUAL
VER. 2 REV. 0
Installation
With the rack bracket it is possible to install up to 12 modules in an organized manner on a 2U rack.
Quick setup
Quick installation procedure below:
•
(For SPI only) Configure the polarity and mode with the switches.
•
(Optional) Insert the modules on the rack bracket or on the din bar.
•
Wire the power supply (Optional standalone ACDC-48 or ACDC-24 power supplies provided separately by 9dot).
•
Connect the power supply pins of the power supply to each module.
•
(Optional) Insert the rack bracket in the structure used to house the devices.
•
Connect the power supply to the electricity.
In addition, both SPIs and SPPs can be installed using the Din rail mounting clip.
Figure 5 - din bar Clip
