AMFLOW
®
A2-ACM Installation, Operation & Service Manual
SERVICE: Adjustments
Copyright
©
2015 A & H Enterprises, Inc. All rights reserved
US & INTERNATIONAL PATENTS PENDING
00000222-0904-000 * Rev. C, 09/15
Page 22 of 35
SECTION 5: SERVICE: Adjustments
5.01 CHECK TORQUE
Step 1
Unscrew and remove M6x10 FH SCREW
(Item 1.15).
Remove COVER HOUSING
(Item 1.2)
by removing all four (4) M4x8 PH SCREWS
(Item 1.8).
Step 2
Rotate HANDLE
(Item 1.1.12.1)
from manual (facing right) to automatic (facing left).
Step 3
Place torque wrench with 6mm drive socket on end of SHAFT ADAPTER
(Item 2).
Be sure SHAFT ADAPTER
(Item 2)
spins between 6.7 and 9 newton meters (60-80 in lbs.).
END OF SECTION
