SELF - DIAGNOSIS
PROGRAMMINGS
The system has the self-diagnosis, that is it constantly checks its good and correct working.
and
of the LED after the desactivation of the system indicate some
anomalies in the system.
In this case we suggest to contact your nearest
installer.
It's possible to customized the system by some programmings
To enter into the PROGRAMMING mode:
Insert and turn the ignition key
and
one time to switch the LED on.
Before the LED is switched off, press its button to
consecutively.
Every time the led switches off for confirmation and the buzzer of the siren gives 1 BEEP.
- Short, low tone BEEP of the buzzer, followed by a very long BEEP and by some LED
flashings.
- When the LED is fixed, we are in the programming phase.
- If the LED switches off autonomously within 2 or 3 seconds, wait for 30 seconds and repeat
the procedure again from point 1.
With the LED lit fixed press its button as many times as the chosen programming (stated in
the following table).
-
On every valid pulse the LED switches off temporarily and the buzzer gives 1 BEEP.
Once terminated the sequence, after some seconds the system signals the programming
has been accepted giving a two tone signal, a series of BEEPS or a musical sequence and
the LED is now lit fixed again.
-
Short BEEPS and very quick flashings of the LED indicate a denial: the made programming
does not exist.
Terminate the procedure turning the ignition key
one time.
The procedure can be started only if the system is desactivated.
Once entered into the programming mode it is possible to set up in succession more
functions.
The completed and confirmed programmings remain active also when the central unit is not
fed.
By a personal PC (or laptop) paired to a programming kit,
, the installer can choose
and carry out in a simple and quick way the programmings stated in the table.
He can also check which programmings are already set up.
Use the
version or one successive.
6 BEEPS
6 short flashings
med
1
ON
OFF
2
11 times
WARNING:
Pressing the LED button the BEEP of the buzzer confirms the signal has been
recognized by the central unit.
Confirmation:
3
4
5
ON / OFF
KIT SK
4.5 med SOFTWARE
WARNING:
!
!
!
!
.
15
Summary of Contents for MED 2200
Page 2: ......
