REMOTE CONTROLS
PIN CARD
PAIRING/CUTTING OUT OF THE REMOTE CONTROLS:
EMERGENCY SYSTEM DESACTIVATION:
USE OF THE PERSONAL CODE
MAINTENANCE
WARRANTY CONDITIONS
They activate/desactivate the system from distance, unlock and lock the doors, control the
windows closing and the paired additional optional modules. They are sealed, antiscanner,
ROLLING CODE and self-learning. Those in the box are ready to use. It is possible to use up to 3
pieces simultaneously, cancel these lost and pair some other, new ones (please ask your
installer). Their duration with normal working is about 2 years.
It’s possible to change the internal battery with one
.
The signal lasts till the transmitter button is pressed.
It is the card supplied in the box, showing the serial number of the central unit and the
PERSONAL CODE, with the relevant use procedure.
It's used to desactive the system when the remote control is not available or broken and it allows
the remote control self learning and their desactivation in case of lost.
Duplicates available on request at the installer's place giving him the “serial number” of the
central unit.
With the system in off position, enter the PERSONAL CODE as shown on the PIN CARD.
When the confirmation the LED is switched on fixed again, within 20 seconds press for three
times consecutively the button of each remote control to be activated or to keep working, waiting
each time the LED relighting.
3 flashings confirm the read in of the remote control.
Once activated the last one (maximum 3 simultaneously), turn on/off the ignition key one time or
wait for 30 seconds.
- The unused remote controls
- The procedure can be cut off only in the initial phase, only if the button of the first remote
control has been pressed for maximum twice.
- After 20 seconds without doing anything the procedure is quitted.
- 2 closed LED flashes mean further remote controls refusal.
As above stated use the PIN CARD following the procedure indicated on it:
Pull off the PIN CARD label: your personal code will appear.
Insert the starting key in
positio.
Move the key in rapid succession (
) without starting the engine for a number of times
corresponding to the first number of your code.
WAIT FOR THE LED CONFIRMATION FLASH (red warning light).
Repeat the steps 3 - 4 for each remaining code numbers.
The usual desactivation signal confirms the operation has been completed successfully.
The central unit does not need any maintenance.
The remote control
internal battery has to be disposed in the suitable containers
according to the single states current standards.
The technical warranty has a duration of 24 months from the date of installation, ex-works, and
covers those parts considered as defective only by A.E.B. S.p.A.
Any other external labor or extra costs are excluded.
CR2032 3 V
WARNING:
WARNING:
during this operation are desactivated; they can be
activated again by repeating the procedure.
1
2
OFF
3
ON-OFF
4
5
TX 4001
5
