Rapid toasteR VCt-250
P/N 00837 Rev. L 03/07
McDonald’s
Rapid toasteR
Model VCt-250
Manufacturing Numbers 9210606, 607, 608, 611, 613, 615, 616, 624 & 626
0/7%2
4%-0
$/
7.
4%-0
50
4%-0
3#!,%
#
&
CAUTION
place this manual in the toaster section
of your
Equipment Manual.
Manufactured exclusively for
McDONALD’S®
BY
A.J. ANTUNES & CO.
80 KEhOE BLvD.
CAROL STREAM, ILLINOIS 6088, U.S.A.
PhONE: -630-784-000
TOLL FREE: -877-392-7854
FAX: -630-784-650
www.ajantunes.com
table of CoNteNts
this manual is for the exclusive use of licensees and employees of Mcdonald’s systems, inc.. © Mcdonald’s Corporation all Rights
Reserved
liMited WaRRaNtY
The Antunes Food Service Equipment Division of A.J. Antunes & Co. provides the following limited warranty to the original purchaser of all McDonald’s Equipment.
All components are warranted against defects in the material and workmanship for a period of two (2) years from date of original installation, not to exceed 30 months
from date of shipment from our factory.
If any part becomes defective during the first two (2) years after the original installation date, Antunes Food Service will pay negotiated straight time labor costs to an
Authorized Service Agent to replace the part, plus travel expenses up to 50 miles/80 km, hour each way (00 miles/60 km, 2 hours round trip).
Antunes Food Service reserves the right to make changes in design or add improvements on any products. The right is always reserved to modify Equipment
because of factors beyond our control and government regulation. Changes to Equipment do not constitute a warranty charge.
This warranty is exclusive and is in lieu of all other warranties, expressed or implied, including any implied warranty of merchantability or fitness for a particular pur-
pose, each of which is expressly disclaimed. The remedies described above are exclusive, and in no event shall A.J. Antunes & Co. or any of its Divisions be liable
for special consequential or incidental damages for the breach or delay in the performance of this warranty.
WaRRaNtY eXClUsioNs
• The cost of Installation.
• Equipment that has been damaged due to shipment. Purchaser should
make damage claim directly upon carrier.
• Alteration, misuse, abuse.
• Improper storage or handling.
• Improper maintenance.
• Failure to follow proper Installation instructions, including electrical connec-
tion.
• Improper or unauthorized repairs.
• Scheduled Maintenance procedures as outlined in your MRC Card.
• Consumables such as Grill Covers (Release Sheets), gaskets, Conveyor Belt
Wraps, O-Rings, and light bulbs.
• Overtime or holiday charges.
• Mileage over 50 miles/80 km (00 miles/60 km round-trip), or travel time
over two (2) hours.
• Fright, foreign, excise, municipal or other sales or use taxes.
• Consequential damages such as loss of profit, loss of time, the cost of repair-
ing or replacing other property which is damaged, or any other incidental
damage of any kind.
owner information .....................................................2
General ......................................................................2
Warranty Information .................................................2
specifications .............................................................2
Model Specifications ..................................................2
Electrical Cord & Plug Configurations .......................2
Dimensions ................................................................3
Weights ......................................................................3
important safety information ....................................4
installation ...................................................................5
Unpacking ..................................................................5
Assembling the Unit ..................................................5
Location .....................................................................5
operation .....................................................................6
Operating Instructions ...............................................6
Toaster Operation ......................................................7
Safety Features .........................................................8
Maintenance ..............................................................10
Daily cleaning ..........................................................0
Measure the Conveyor Belt Chains for Stretch ......2
Replacing Belt Wraps .............................................3
Checking the Temperature of the Bun Landing Area 4
Adjusting, Measuring and/or Replacing Roller
Tensioner Assemblies ..............................................4
troubleshooting .......................................................15
Replacement parts ..................................................18
Wiring diagrams .......................................................23
service/technical assistance .................................24
A
S
D
L I S T E
CM
O
I N
NIT A T
Testing & Certification
ITS
geprufte
Sicherheit
