Contents:
Step
1
. Network settings for Internet connection.
(This step has computer network settings needed for Internet connection)
Step
2
. Failure analysis chart.
(If you face problems with modem, follow this chart)
Step
3.
Activate wireless network
(This step show how wireless network can be activated)
Step
4.
Setting up wireless network and security.
(This step advice how to take wireless connection with encryption in use)
Start installation:
Defaults in V100AP VDSL2 modem depend on your operator VDSL2 connection. Modify/check only your computer
network settings as in below step
1.
and your Internet connection is ready to use.
If you want to use modem wireless connection, it is
extremely important
to add encryption to protect your wireless
connection as in step
4.
”
Setting up wireless network and security
” has been told. Wireless network is not active in
defaults. To take wireless network in use, follow settings as in step
3.
and protect your wireless network as in step
4
.
Supported browsers are Internet Explorer 5.x, Netscape 6.x or later.
Internet browser can not have any Proxy setting configured.
Reset to factory defaults:
Factory defaults can be reset when you press reset button back of the modem about 10 seconds when modem have
power on.
Note!
Make sure before you connect your computer to modem, that you have firewall software installed and turned
on to your computer.
4
Summary of Contents for V100AP
Page 15: ...Pika asennusohje V100AP 15 ...
