A
NEU
VIDEO
2
TABLE OF CONTENTS
INTRODUCTION & CONTENTS .......................................................................................................2
FEATURES........................................................................................................................................3
SPECIFICATIONS......................................................................................................................4
OPERATION CONTROLS & FUNCTIONS.......................................................................................5
IR PIN DEFINITION...........................................................................................................................7
EDID MODE.......................................................................................................................................8
CONNECTION DIAGRAM.................................................................................................................9
INTRODUCTION
This HDMI 1x4 Splitter can distribute (1) HDMI source signal to any (4) display devices. Supports
video resolution up to 4K@30Hz 4:4:4. It is designed with (1) HDMI input, (1) HDMI loop output
and (4) CAT outputs. The HDMI signal transmission distance can be extended up to 131 ft (40M)
at the resolution of 4K30Hz, or 230 ft (70M) at 1080P@60Hz via a single CAT6 cable. The product
supports one-way IR return and advanced EDID management. This product has a 3 year warranty.
PACKAGE CONTENTS
Before attempting to use this unit, please check the packaging and make sure the following items
are contained in the shipping carton:
•
HDMI 1x4 Splitter
• (4) CAT Receiver
•
IR Blaster Cable (1.5M)
•
(4) IR Receiver Cable (1.5M)
•
(2) Mounting Ear
•
12V/2.5A DC Locking Power Adapter
• (8) Machine Screw (KM3x4)
• User Manual
NOTES
For the best results, it is suggested you use pure copper and not copper clad aluminum and use
solid, riser rated cable and not stranded cable. Stranded cable has ~20% higher signal attenuation
than solid, so its runs need to be shorter.
Contiguous cable runs are preferred. The use of network punch down into patch panels and keystone
jacks adds attenuation and runs need to be shorter.
The use of EZ-45® connectors are not recommended as the cable extends outside the end of the
RJ45 connector and can act as an inductor of noise.
Summary of Contents for ANI-0104POE-XT
Page 11: ...CONNECTION DIAGRAM 9 ...
