13
RS-232 & TELNET COMMANDS
RS-232 & Telnet Commands
HDMI MIRRORING COMMAND EXAMPLE
If you have rack (head end) based AVR’s for surround sound rooms we recommend using the HDMI outputs and the HDMI mirroring
mode to easily have the audio and video sent to the AVR follow the signal sent to that zone’s TV.
As long as no further commands are ever sent to the HDMI outputs of the matrix you only need to set this up once:
COMMAND
DESCRIPTION
HDMI_Out I Mirroring=HDBT_Out A
Set HDMI output
“I”
to mirror HDBaseT
™
output
“A”
When using the mirroring function you can use any standard commands with the mirrored HDBaseT
™
output and the mirroring HDMI
output will follow the commands. These can be an A/V Pairing, Video or Audio commands, etc.
AUDIO ONLY SOURCE SELECTION COMMAND EXAMPLES
This unit offers (8) direct audio only inputs, while some of these inputs will likely be used for down mixed audio signals from surround
sound sources (for stereo only zones) we expect audio only sources to be connected to deliver just audio to both TV zones and Audio
Only zones.
COMMAND
DESCRIPTION
ZoneLineOut A AudioSrc=AnalogIn 1
Route Analog input 1 to Zone Audio output
“A”
ZoneLineOut A AudioSrc=OpticIn 1
Route Optical input 1 to Zone Audio output
“A”
ZoneLineOut A AudioSrc=CoaxIn 1
Route Coaxial input 1 to Zone Audio output
“A”
ExtLineOut 1 AudioSrc=AnalogIn 1
Route Analog input 1 to Extended Line output
“1”
ExtLineOut 1 AudioSrc=OpticIn 1
Route Optical input 1 to Extended Line output
“1”
ExtLineOut 1 AudioSrc=CoaxIn 1
Route Coaxial input 1 to Extended Line output
“1”
Above are just a few example of the audio selections available. Please refer to the full command listing for all possible commands.
Remember if you have configured any audio zones to play the OAR audio from the TV within a zone you must be able to select this
again to return to
“listening”
to that TV.
INDIVIDUAL AUDIO AND VIDEO ROUTING COMMAND EXAMPLES
To offer the greatest level of flexibility the matrix can be used to send individual commands for both video and audio, this allows the
installer to completely tailor the matrix to suit any possible configuration the end user may require.
Route audio and video from HDMI input 1 to HDBaseT
™
output A independently:
COMMAND
DESCRIPTION
HDBT_Out A VideoSrc=HDMI_In 1
Video switch command
HDBT_Out A AudioSrc=HDMI_In 1
Audio switch command
COMBINED AUDIO AND VIDEO ROUTING COMMAND EXAMPLE
It is also possible to switch audio and video simultaneous by using an advanced command structure. In this case the individual
parameters of the
“HDBT_Out”
command are separated by a comma.
Route audio and video from HDMI input 1 to HDBaseT
™
output A simultaneously:
COMMAND
DESCRIPTION
HDBT_Out A VideoSrc=HDMI_In 1,
AudioSrc=HDMI_In 1
Video and Audio switch command
Every individual audio and video input has a bespoke command (including separate commands for the audio and video within a HDMI
source).
A
NEU
VIDEO
Summary of Contents for ANI-1082UHD-KIT
Page 33: ...CONNECTION DIAGRAM CONNECTION DIAGRAM MAIN UNIT A NEUVIDEO 31 ...
Page 34: ...32 CONNECTION AND INSTALLATION CONNECTION AND INSTALLATION RECEIVER A NEUVIDEO ...
Page 35: ...IR CABLE PIN ASSIGNMENT IR Cable Pin Assignment A NEUVIDEO 33 ...
