ENG 14
12. Connect the inlet tube to the adaptor.
13. Be sure that the inlet hose is not twisted or
bended. It could cause water and electric leakage.
14. Before use, entirely close the cold tank cover
in the unit.
Insects or foreign substances may get
inside of the product.
15. Do not use product for at least one hour after
the product is moved to another place.
1 hour after...!
Operation Methods
1.
Turning on the Power
1.1.Before supplying electric power to the unit, check that “Hot Water
Switch” and “Cold Water Switch” are both in closed position.
WARNING:
If during the plug in, the Hot Water Switch was on then
the device will emit a thermostat. In such a case thermostat should
be reset. During reset the device should not be connected to the power
supply. Otherwise there a risk of electric shock.
1.3. After connecting to the power, the unit will start to fill the tanks.
At this point before the tanks start to take water, do water flushing
process to each filter for more than 10 mins, until white, black or bub
ble water doesn't come out from the filter. For sediment and pre-car
bon filter, disconnect them from the membrane and dump the water
for 10 mins.
For post carbon filter, disconnect it from the tank and dump the water
for 10 mins.
WARNING:
Even the filters are flushed, it is recommended to dump
first 20 liters of water after the initial operation
1.2. After being sure that Hot and Cold water switches are off, connect
the unit to the electricity.
