15
A3-P
4.9 ITEMS TO BE PERFORMED BEFORE OPERATING THE MACHINE
Once the machine has been properly installed (as previously described), check that:
• The magazine is loaded with the type of Wedges suitable with the mouldings to be assembled
• The adjustment of the vertical and horizontal clamps are correct (chapter 4.8.2 and 4.8.3)
• The protective shield is properly positioned (see chapter 4.8.5)
• The working pressure is adequate to the wood hardness (see chapter 4.8.4)
• The mouldings to be assembled are properly positioned on the work bench
• Pressing halfway down on the pedal both the frontal and vertical clamps hold the frame properly
•
Press the pedal all the way down to insert the wedge
If you want to insert 2 or more wedges one upon the other in the same position, you must
release the pedal until halfway and then press it full down again to insert the second wedge
Summary of Contents for A3-P
