A-PLUS AUTOMATION A3-P, Instruction Handbook Manual

19

A3-P

7.3  TECHNICAL SERVICE REQUEST PROCEDURES

For any requirement, please contact the Manufacturer’s Customer Service.

For any request for technical service, list the data on the identification plate, the approximate number of hours the 

machinery has been used and the type of malfunction.

E_Mail: service@a-plusautomation.com

FAX: +39-0543-480770

Via Selva, 23/25 - 47122 Forlì - Italy

In the USA please contact: 

E_Mail: service@a-plusautomationusa.com

FAX: 248-851-8777

31874 Northwestern Highway

Farmington Hills, MI 48334

8. SPARE PARTS

8.1  SPARE PARTS LIST

Even though the  machine has been submitted to several tests and functional checks, we listed below the 

components that we suggest you to have a minimum and sufficient set of. This will help guarantee the shortest 

possible downtime.

TABLE  8.1 - A

COMPONENT

•  WEDGES DRIVER BLADE 

•  WEDGES CLAW-HEADS 

•  “L” SHAPED SUPPORT (WEDGES GUIDE) 

•  VALVES-REDUCERS-REGULATORS 

•  VERTICAL AND HORIZONTAL CLAMPING 

•  GASKETS

8.2  SPARE PARTS ORDERING

We remind you that only a qualified technician can repair the machine.

Therefore we suggest the intervention of your local distributor or A-Plus Automation Center of Technical Assistance, 

which has access to qualified staff, proper equipment and tools, and who uses original spare parts.

To order the above spare parts, send the following data by fax, e-mail or letter: 

•  Model of the Machine

•  Code of drawing scheme

•  Reference number of spare part or group indicated on the mechanical drawing

•  Code number of single or group spare part

9. MACHINE DEMOLITION

9.1  MACHINE DEMOLITION

When scrapping the machine, group components by chemical composition and dispose of separately in accordance 

with applicable legislation. Do not dispose of non-biodegradable materials, lubricant oils and non-ferrous articles 

(rubber, PVC, plastics etc.) in the environment. 

10.  ATTACHMENTS

10.1  DECLARATIONS

You can find here attached the following declarations

•  Declaration of conformity to the Norm 89/392/CEE

10.2  SCHEMATICS 

You can find here attached the following schemes:

•  (A) Mechanical Schematic

•  (B) Pneumatic Schematic

•  (C) Plate locations

•  (D) Sharpening Table