12
A44-P
4.7.2 Nail guide head replacement to change Wedges size
The nail guide head must be changed each time you use nails of different sizes. Proceed as follows to replace it:
• Loosen the locking screw of the nail guide head using the proper
5 mm Allen wrench (the screw is on the opposite side from the
nails magazine(See pic. 4.7.2.1)
• Take out the nail guide head
Picture 4.7.2.1
• Move the clawpusher backwards (as per par. 4.7.1).
• Remove all the nails that are still in the magazine (using the proper
brass magnet, if necessary). See pic. 4.7.2.2.
Picture 4.7.2.2
• Insert the new nail strip (of desired height) into the magazine
• Close the magazine (as per par. 4.7.1).
• Insert the new size nail guide head to match the nails you will be
using (see pic. 4.7.2.3).
• Tighten the locking screw of the nail guide head (see pic. 4.7.2.1).
Picture 4.7.2.3
Summary of Contents for A44-P
