Operating Instructions and Parts List
AR112
6
www.arnorthamerica.com
• NEVER allow the unit to run
with the trigger release (off)
for more than one (1) minute.
Resulting heat buildup will
damage pump.
• Pressure washer is not meant
to pump hot water. NEVER
connect it to a hot water supply
as it will significantly reduce the
life of the pump.
• NEVER store the pressure
washer outdoors or where it
could freeze. The pump will be
seriously damaged.
• Release trigger when changing
from high to low pressure
modes. Failure to do so could
result in damage.
Keep hose away
from sharp
objects. Bursting hoses may cause
injury. Examine hoses regularly
and replace if damaged. Do not
attempt to mend a damaged hose.
1. Attach swivel adapter to pump
water inlet, if not already
attached. Notice the swivel
adapter is marked with the
words pump and hose. Make
sure to connect pump side of
the adapter to the pump water
inlet to prevent damage to the
threads.
2. Attach garden hose to swivel
adapter side marked hose.
3. The spray gun should be locked
into the “OFF” position by
locating the safety trigger
lock just above the trigger of
the gun. Activate the lock by
holding the gun and push the
lock from left to right. Squeeze
trigger to make sure the trigger
does not move. The safety
trigger lock should be locked at
all times when pressure washer
is not in use.
1. Plug the power cord into a
grounded 120V outlet and
press the reset button as shown
below.
2. THIS MUST BE DONE EACH
TIME THE UNIT IS PLUGGED IN
AN OUTLET.
P
oWer
c
ord
S
erVicinG
of
a
d
oUble
-
i
nSUlated
a
PPliance
(
cont
)
G
arden
h
oSe
c
onnection
i
nStrUctionS
Pump
Hose
Reset
