4
English
DMP81
DIP SWITCH
DMP81 is equipped with two DIP switches on the rear panel, which is offering various setup options and for turning ON/OFF
the phantom power for each channel�
DIP Switch 1 (for adjusting setup options)
DIP Switch 2 (for turning phantom power ON/OFF)
This DIP switch is used for turning ON/OFF the +48V phantom power for each channel� The number labeled under each
switch is corresponding to the channel numbers�
Manual/Auto:
In Manual mode, DMP81 works as a
standard 8x1 mixer� In Auto Mode, the input drops by
3 dB every time the number activated inputs doubles�
When in MANUAL mode, the master output drops by 9
dB when all 8 channels are activated� And it will increase
by 9 dB when in AUTOMATIC mode�
Last Mic Lock-On
: And only the most recently activated
channel will be enabled until the another channel is
enabled. When this function is turned off, channel
disables after the preset hold time�
Switch Number
1
2
3
4
7
8
Switch Function
Auto /
Manual
Last Mic
Lock-on
Hold
Time
Off-Att
Limiter Threshold
Switch Up (On)
Auto
Enabled
0�4 sec
-15db
7 Up
8 Up
= LIM off
7 Up
8 Down
=+16 dBm
Switch Down (Off)
Manual
Disabled
1�0 sec
-
∞
7 Down
8 Up
=+8 dBm
7 Down
8 Down
=+4 dBm
Hold Time:
Adjusts the time an activated channel (which
is not locked on) remains on after the
t
alker stops talking�
Settings are 0�4 seconds or 1�0 second�
Off-Attenuation:
Adjusts the off-attenuation level from
15 dB to infinity (-∞). With the 15 dB setting, an unused
microphone is 15 dB lower in level than when it is
activated. With the -∞ setting, an unused microphone is
completely off.
Limiter Threshold:
Adjusts the limiter threshold for
outputs� Settings are OFF, +16 dBm, +8 dBm, or +4 dBm�
