Page 6
09/2021
Installation and Operating Instructions
UPS Edition One 1kVA, 2kVA, 3kVA
1.3 Preparation
■
If the UPS system is brought directly from a cold to a warm environment,
condensation may occur. The UPS system must be absolutely dry before it
is installed. Please allow at least 2 hours for the UPS to acclimatise to the
environment.
■
Do not install the UPS system near water or in humid environments and
generally keep liquids away from the UPS system.
■
Do not install the UPS system near a heater or in a place where it is exposed
to direct sunlight.
■
Do not block any ventilation openings in the UPS enclosure and maintain
the minimum distances from neighbouring equipment or walls necessary for
ventilation.
■
Never operate the UPS in an explosive and/or unventilated environment.
1.4 Installation
■
To avoid electrical hazards, the UPS should only be connected in a de-
energised state.
■
Do not connect any loads to the UPS that could overload the unit.
■
Lay cables so that no one can step on them or trip over them and keep them
as short as possible.
■
Do not connect any household or handicraft appliances such as hair dryers,
fan heaters, hoovers, drills etc. to the output sockets of the UPS.
■
Only connect the UPS system to an earthed socket outlet that is easily
accessible and close to the UPS system.
■
Please use only VDE-tested, CE-marked mains cables (e.g. the mains cable of
your computer) to connect the UPS system to the mains socket of the house
installation (earthed socket).
■
Please use only VDE-tested, CE-marked mains cables to connect the loads to
the UPS system.
■
Use generally installation-appropriate tools with insulated handles.
■
During installation, make sure that the sum of the leakage current of the UPS
and the connected devices does not exceed 3.5mA.
