Digital Video Recorder User Manual
All the parameters should be exactly the same as the PTZ camera parameters.
For the Coaxitron camera/dome connected, you can select the PTZ protocol to UTC
(Coaxitron). Make sure the protocol selected here is supported by the connected
camera/dome.
When the Coaxitron protocol is selected, all the other parameters like the baud rate, data
bit, stop bit, parity and flow control are not configurable.
Step 5 (Optional) Click
Copy
button to copy the settings to the other channels. Select the channels
you want to copy to and click
OK
to return to the
PTZ Parameters Settings
interface.
Figure 4-3 Copy to Other Channels
Step 6 Click
OK
to save the settings.
Step 7 (Optional) Check the checkbox of
Enable Omnicast Control
to enable the PTZ control of the
selected camera via Omnicast VMS of Genetec.
4.2 Setting PTZ Presets, Patrols and Patterns
Before you start
Please make sure that the presets, patrols and patterns should be supported by PTZ protocols.
4.2.1 Customizing Presets
Purpose
Follow the steps to set the Preset location which you want the PTZ camera to point to when an
event takes place.
Step 1 Enter the
PTZ Settings
interface.
58
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
