2
/
20
Receiving Shipment
Upon taking delivery of your machine, carefully inspect the assembly before removing the crating
and packing materials.
If evidence of damage exists, contact the shipper immediately. Although we are not responsible
for damage incurred during transit, you will be provided assistance in preparation and filling of
any necessary claims.
CAREFULLY READ THIS MANUAL BEFORE ATTEMPTING TO SET-UP OR OPERATE THIS MACHINE.
Important Note:
Always have your serial number ready when communicating with us regarding parts or service.
Keep this manual in a safe place.
Date Received:
Serial Number:
SAFETY FIRST
This manual has been prepared for the owner and those responsible for maintenance of this
machine. Its purpose aside from proper maintenance and operations is to promote safety
through the use of accepted practice. READ THE SAFETY AND OPERATING INSTRUCTIONS
THOROUGHLY BEFORE OPERATING THE MACHINE.
In order to obtain maximum life and efficiency from your machine, follow all the instructions in
the operating manuals carefully.
The specifications put forth in this manual were in effect at the time of publication. However,
owing to our policy of continuous improvement, changes to these specifications may be made at
any time without obligation.
SAFETY INSTRUCTIONS
1.
Read, understand and follow
the safety and operating instructions found in this manual.
Know the limitations and hazards associated with operating the machine.
2.
Eye Safety:
ear an approved safety face shield, goggles or safety glasses to protect eyes when
operating the machine.
3.
Grounding the Machine:
Machines equipped with three prong grounding plugs are so
equipped for your protection against shock hazards and should be plugged directly into a
properly grounded three-prong receptacle in accordance with national electrical codes and
local codes and ordinances. A grounding adapter may be used.
4.
Work Area:
Keep the floor around the machine clean and free of tools, tooling, stock scrap
and other foreign material and oil, grease or coolant to minimize the danger of tripping or
slipping. We recommend the use of anti-skid floor strips on the floor area where the
operator normally stands and that each machine’s work area be marked off. Make certain the
work area is well lighted and ventilated. Provide for adequate workspace around the
machine.
5.
Guards:
Keep all machine guards in place at all times when machine is in use.
6.
Do Not Overreach:
Maintain a balanced stance and keep your body under control at all times.
7.
Hand Safety:
NEVER wear gloves while operating this machine.
8.
Machine Capacity:
Do not attempt to use the machine beyond its stated capacity or
operations. This type of use will reduce the productive life of the machine and could cause
the breakage of parts, which could result in personal injury.
9.
Avoid Accidental Starting:
Make certain the main switch is in the OFF position before
Summary of Contents for C9372
Page 13: ...13 20 Cross Feed Feed Slide Assembly ...
Page 20: ...20 20 WIRING DIAGRAM ...