4
/
20
Net Weight 590 lbs. (270Kg)
CONTROLS AND SWITCHES
Spindle Motor Switch
(Item 1, Figure 1)
The spindle motor switch is a two position toggle switch. When switch OFF, all power to the
spindle motor is shut off. When switched ON, the spindle motor starts. The spindle will begin to
rotate.
Disc/Drum Switch
(Item 2, Figure 1)
This switch is a three position select switch. When the left side of this switch is depressed, power
is supplied to the Disc feed motor. When the right side of the switch is depressed, power is
supplied to the Drum feed motor. When the switch is in the neutral position (centered), power to
both motors is OFF.
Disc Stop Switch
(Figure 2)
This switch is a two position limit switch, which serves as an
automatic shut-off of the Disc feed motor. In order for power to be
supplied to the Disc feed motor, the limit plate must be away from
the switch.
Fig.2
Drum Stop Switch
(Figure 3)
This switch is a micro switch, which serves as an automatic shut-off
of the Drum feed motor. In order for power to be supplied to the
Drum feed motor, the limit plate must be away from the switch.
Feed Screw Hand wheel
(Figure 3)
This handwheel is used to move the feed slide plate either left or right as you face the front of
the machine.
Cross Slide Hand wheel
(Figure 2)
This hand wheel is used to move the feed slide plate either in or out as you face the front of the
machine.
INSTALLATION INSTRUCTIONS
After uncrating, check for HIDDEN DAMAGE. If any is found, CONTACT YOUR CARRIER
Summary of Contents for C9372
Page 13: ...13 20 Cross Feed Feed Slide Assembly ...
Page 20: ...20 20 WIRING DIAGRAM ...