AMB-2020HT(T)-E User’s Manual
30
RTC Alarm Function
This field enables or disables the RTC Alarm.
PM Events
The I/O events prevent the system from entering a power saving mode or can awaken the system from
such a mode. When an I/O device wants to gain the attention of the operating system, it signals this by
causing an IRQ to occur. When the operating system is ready to respond to the request, it interrupts itself
and performs the service. The default value is
Off
. When set On, activity will neither prevent the system
from going into a power management mode nor awaken it. The IRQ section sets the wake- up call of the
system. If activity is detected from any enabled IRQ channels in the left-hand group, the system wakes up
from suspended mode.
PNP/PCI Configuration
This option configures the PCI bus system. All PCI bus systems on the system use INT#, thus all installed
PCI cards must be set to this value.
ROM PCI/ISA BIOS
PNP/PCI CONFIGURATION
AWARD
SOFTWARE INC.
PNP OS Installed
: Yes
PCI IRQ
Activated By
: Level
Resources Controlled by
: Manual
Reset Configuration Data
: Disabled
Used MEM base
addr
: N/A
IRQ-3
assigned to
: Legacy ISA
IRQ-4
assigned to
: Legacy ISA
IRQ-5
assigned to
: Legacy ISA
IRQ-7
assigned to
: Legacy ISA
IRQ-9
assigned to
: Legacy ISA
IRQ-10 assigned to
: Legacy ISA
IRQ-11 assigned to
: PCI/ISA PnP
IRQ-12 assigned to
: PCI/ISA PnP
IRQ-14 assigned to
: PCI/ISA PnP
IRQ-15 assigned to
: PCI/ISA PnP
DMA-0 assigned to
: PCI/ISA PnP
DMA-1 assigned to
: PCI/ISA PnP
ESC : Quit
á
â
ß
: Select Item
DMA-3 assigned to
: PCI/ISA PnP
F1 : Help
PU/PD/+/- : Modify
DMA-5 assigned to
: PCI/ISA PnP
F5 : Old
Values
(Shift) F2 : Color
DMA-6 assigned to
: PCI/ISA PnP
F6 : Load BIOS Defaults
DMA-7 assigned to
: PCI/ISA PnP
F7 : Load Setup Defaults
PNP OS Installed
This field allows you to specify if the operating system installed in your system is plug and play aware.
NOTE
:
Operating systems such as DOS, OS/2, and Windows 3.x do not use PnP.
Resources Controlled by
This PnP BIOS can configure all of the boot and compatible devices automatically. However, this
capability needs you to use a PnP operating system such as Windows 95 and Windows 98. The default
value is
Manual.
