Chapter 2
–
Hardware Information
8
Co
m
pa
ct F
anl
ess Embe
dd
ed
AI@
Edge
Bo
x PC
BO
XER
-8
130AI
2.3 List of Jumpers
The board has a number of jumpers that allow you to configure your system to suit
your application.
The table below shows the function of each of the board's jumpers
Label
Function
CN17
AT mode select
2.3.1
Setting Jumpers
You configure your card to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch. It consists of two metal pins and a small
metal clip (often protected by a plastic cover) that slides over the pins to connect them.
To “close” a jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will have three pins,
labeled 1, 2 and 3. In this case you would connect either pins 1 and 2 or 2 and 3.
1 2
3
Open Closed Closed 2-3
A pair of needle-nose pliers may be helpful when working with jumpers.
If you have any doubts about the best hardware configuration for your application,
contact your local distributor or sales representative before you make any change.
Generally, you simply need a standard cable to make most connections.
Summary of Contents for BOXER-8130AI
Page 17: ...Compact Fanless Embedded AI Edge Box PC BOXER 8130AI Chapter 2 Chapter 2 Hardware Information...
Page 33: ...Chapter 2 Hardware Information 21 Compact Fanless Embedded AI Edge Box PC BOXER 8130AI...
Page 37: ...Compact Fanless Embedded AI Edge Box PC BOXER 8130AI Chapter 3 Chapter 3 OS Flash guide...
