Chapter 3 – OS Flash guide
21
Co
mp
act
Fan
less
E
mb
ed
ded
AI@
Ed
ge
Bo
x
PC
BO
XE
R-
815
0AI
3.1 Force USB Recovery Mode
To place system in Force USB Recovery Mode:
1.
Power down the device and disconnect the AC adapter. The device MUST be
powered OFF, not in a suspended or sleep state.
2.
Connect the Micro-B plug on the USB cable to the Recovery (USB Micro-B) Port
on the device and the other end to an available USB port on the host PC.
3.
Connect the power adapter to the device.
4.
Press and release the POWER button to power on device. Press and hold the
FORCE RECOVERY button. While pressing the FORCE RECOVERY button, press and
release the RESET button; wait two seconds, and then release the FORCE RECOVERY
button. Refer to Chapter 2 Hardware Information for button locations.
5.
When device is in recovery mode, lsusb command on host will list a line of
"NVidia Corp."
