3-9
Chapter 3: BIOS setup
3.3.7
Power Management
Power Mode [ATX Type]
This item selects Power Supply Mode. Configuration options: [ATX Type] [AT
Type]
Restore AC Power Loss [Always Off]
[Always On]
The system goes into on state after an AC power loss.
[Always Off]
The system goes into off state after an AC power loss.
[Last State]
The system goes into either off or on state, whatever
the system state was before the AC power loss.
RTC wake system from S5 [Disabled]
Allows you to enable or disable system wake up on alarm event. When you select [Fixed
Time], the system will wake up on a specified time. When you select [Dynamic Time], the
system will wake up on the current time. Configuration options: [Disabled] [Fixed Time]
[Dynamic Time]
3.3.8
Digital IO Port Configuration
The items in this menu allow you to modify Digital IO settings.
DIO Port 1~4 [Output]
Set DIO data flow as Input or Output. Configuration options: [Input] [Output]
Output Level [High]
Configuration options: [High][Low]
DIO Port 5~8 [Input]
Set DIO data flow as Input or Output. Configuration options: [Input] [Output]
3.4
Chipset menu
The Chipset menu items allow you to change configuration options for the North
Bridge and South Bridge.
3.4.1
North Bridge
Primary Display [IGD]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [IGD] [PCIe]
Primary IGFX Boot Display [Auto]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [Auto] [HDMI1] [eDP/LVDS] [CRT]
