38 PCM-4335 User Manual
Quick Boot
Set this option to Enabled to instruct AMIBIOS to boot quickly
when the computer is powered on. This option replaces the old
"Above 1 MB Memory Test" Advanced Setup option.
Setting
Description
Disabled
AMIBIOS tests all system memory. AMIBIOS waits up to 40
seconds for a READY signal from the IDE hard disk
drive. AMIBIOS waits for .5 seconds after sending a
RESET signal to the IDE drive to allow the IDE drive
time to get ready again. AMIBIOS checks for a <Del>
key press and runs AMIBIOS Setup if the key has
been pressed.
Enabled
AMIBIOS does not test system memory above 1 MB.
AMIBIOS does not wait up to 40 seconds for a
READY signal from the IDE hard disk drive. If a
READY signal is not received immediately from the
IDE drive, AMIBIOS does not configure that drive.
AMIBIOS does not wait for .5 seconds after sending a
RESET signal to the IDE drive to allow the IDE drive
time to get ready again.
You cannot run AMIBIOS Setup at system boot,
because there is no delay for the
Hit <Del> to run
Setup
message.
Boot Up Num Lock
Set this option to Off to turn the Num Lock key off when the
computer is booted so you can use the arrow keys on both the
numeric keypad and the keyboard. The settings are On or Off.
The default setting is On.
Floppy Drive Swap
Set this option to Enabled to permit drives A: or B: to be
swapped. The settings are Enabled or Disabled. The default
setting is Disabled.
PS/2 Mouse Support
When this option is set to Enabled, AMIBIOS supports a PS/2-
type mouse. The settings are Enabled or Disabled. The default
setting is Enabled.
