R u g g e d T a b l e t C o m p u t e r
R T C - 7 0 0 C
Chapter 2 Making Connections
2-17
1.4 Quick Start
Turning on the Rugged Tablet Computer for the First Time
For first-time use, you need to charge your RTC for four hours. After
that you can recharge the battery as needed.
1.
Connect the AC adapter power cord to the AC adapter.
2.
Connect the AC adapter to the DC-in jack on the right side of your
RTC.
3.
Connect the AC adapter power cord to an AC outlet.
4.
Press the power button to turn on the power.
Note:
The battery is not fully charged. Allow your battery to fully charge
before using it (i.e., before disconnecting AC power). Calibrating the battery
before use is also highly recommended.
It is normal for the RTC surface to become warm during charging or long
periods of use.
Refer to Chapter of
Power Management
for further information.
4
Summary of Contents for RTC-700C
