E m b e d d e d C o n t r o l l e r
T K S - G 2 0 - L N 0 5
3.1 System Test and Initialization
These routines test and initialize board hardware. If the routines
encounter an error during the tests, you will either hear a few short
beeps or see an error message on the screen. There are two kinds
of errors: fatal and non-fatal. The system can usually continue the
boot up sequence with non-fatal errors.
System configuration verification
These routines check the current system configuration against the
values stored in the CMOS memory. If they do not match, the
program outputs an error message. You will then need to run the
BIOS setup program to set the configuration information in memory.
There are three situations in which you will need to change the
CMOS settings:
1. You are starting your system for the first time
2. You have changed the hardware attached to your system
3. The CMOS memory has lost power and the configuration
information has been erased.
The TKS-G20-LN05 CMOS memory has an integral lithium battery
backup for data retention. However, you will need to replace the
complete unit when it finally runs down.
Chapter 3 AMI BIOS Setup
3-2
Summary of Contents for TKS-G20-LN05
Page 18: ...Embedded Controller T K S G 2 0 L N 0 5 Chapter 2 Quick Installation Guide 2 4 Solder Side ...
Page 31: ...Embedded Controller T K S G 2 0 L N 0 5 Chapter 3 AMI BIOS Setup 3 1 AMI Chapter 3 BIOS Setup ...
Page 46: ...Embedded Controller T K S G 2 0 L N 0 5 Appendix B DIO B 1 DIO Appendix B ...
