Operators and Maintenance Manual
Measuring module
EMS DAQ R02.01
Page
4/18
Copyright:
Auto & Aero Technologies Sp. z o.o.
Mazowiecka 10/5, 20-723 Lublin, Poland
■
email: info@aatech.pl
■
www.aatech.pl
c)
recording flight time: from last engine start, and the total engine
operation time (HOOBS).
The module is designed to work with ROTAX 912 UL, 912 ULS and 914
engines. A list of signals processed by the module together with sensor
types is presented in Table 1.
Tab. 1
Sensors providing input for EMS DAQ R02.01 Module
No.
Parameter
Sensor
1
Engine speed
BRP TRIGGER COIL KIT
264087
1
2
Rotor speed
Autonics PR08-1.5DN
3
Inlet air pressure
Bosch 0 281 002 976
4
Oil pressure
BRP 456180
1
5
Oil temperature
BRP TEMPERATURE
SENSOR 965531
1
6
Cylinder head
temperature
BRP TEMPERATURE
SENSOR 965531
1
(2
sensors)
7
Exhaust gases
temperature
BPR THERMO COUPLE
NICR-NI K 966370
1
(2
sensors)
8
Inlet air
temperature
Bosch 0 281 002 976
9
Fuel level
Vdo 224-011-020-372g
10
Trim pitch and roll
Signal from actuator
Linak La 12
1
Standard sensor for ROTAX engine
The
module’s casing made of black ABS is
splash-proof. Cables connecting
sensors with printed circuit board of the device enter the casing via screw
connection terminal blocks. The opening is sealed by means of sealing
foam tape pasted to both parts of the casing.
Hardware identification plates are located in the front of the casing (Fig. 1)
and inside (on circuit board).
