2.1 Mounting to the Yaw Pole
Slide the yaw pole onto the yaw shaft of the head assembly and fastened by four
bolts M8/15 with flat washers and lock washers.
2.2 Mounting the Rotor Hub
1. Remove the nut, lock washer and flat washer from the alternator shaft;
2. Slide the rotor hub onto the alternator shaft and put on the flat washer and
lock washer;
3. Thread and tighten the nut. The nut should be tightened to 70-85 Nm.
2.3 Mounting the Rotor Blades
1. Blades should be in front of the rotor hub, with the flat side facing upwind.
2. Insert three bolts in the holes on the hub and blade. Place flat washers on
the end of the bolts, thread and tighten Nylock self-locking nut. Nuts
should be tightened to 8-12 Nm.
2.4 Attaching the Front Cover
Place the spinner over the center of the hub. Thread the M6*35bolt with the lock
washer and flat washer into the screw hole on the alternator shaft and tighten by
hex key (Allen wrench).
1. Drill through the tower tube to the electric wire
2. Attach the wind turbine head assembly
