8
2.1. Display
Displays the weighing data received. When the unit is “g” (gram), the unit indicator turns on. If the
balance outputs RS-232C weighing data that exceeds six digits, the AD-8923-CC does not display the
high-end digits. (2 highest digits for an 8 digit display)
Weight value of the CC-link is output even if it exceeds six digits.
When the weight value is stable (the header of the weighing data received is “ST”), the STABLE
indicator turns on.
If the AD-8923-CC does not receive the weighing data for two seconds or more,
is
displayed (Bar display).
When AD-4212C
/
D
/
F is connected, displays the AD-4212C
/
D
/
F weighing speed that is currently
set, by turning on the weighing speed indicator. When connected to other instruments, the AD-8923-
CC weighing speed indicators have no function.
2.2. Keys
Used to operate the weighing instruments. For details, refer to “
”.
To enter the function setting of the AD-8923-CC, press the CAL key while holding down
the ON:OFF key.
For details, refer to “
”.
2.3. Connectors
RS-232C connector ...... D-Sub 9-pin (male)
Used for connection to the weighing unit. For the proper cable, refer to the instruction manual for the
weighing instrument used.
CC-Link connector........ 5-pin (male)
Used to connect to other AD-8923-CCs, PLCs or other CC-Link devices. For details, refer to “
”.
DC input terminal (24 DCV)
/
AC adapter input jack
Either power supply can be used. For details, refer to “
”.
AD-8923
REMOTE CONTROLLER
ON:OFF
CAL
SAMPLE PRINT
MODE
RE-ZERO
STABLE FAST
MID.
RESPONSE
SLOW
Weighing speed
indicators
Turns on while the
weighing instrument is
in the standby mode.
STABLE indicator
Unit indicator
Summary of Contents for AD-8923-CC
Page 1: ...1WMPD4002124D...
Page 32: ...32 MEMO...
Page 33: ...33 MEMO...
Page 34: ...34 MEMO...
