AD4329A-DLC
Page 34
If you use the standard serial output, configure
the following settings:
・
Select output data (F-30) from the following settings:
0: Displayed value (default)
1: Gross value
2: Net value
The preset tare value may be output depending on the setting (CF-007).
3: Tare value
4: Gross + Net + Tare value If you connect a printer without receive buffer, set the data interval (F-33)
to 1: 2 seconds
・
Select communication mode (F-31) from the following settings:
0:
Stream (default)
Weighing data is output at the display update rate (F-03).
1: Auto print
When the MD mark is illuminated, weighing data is output.
Once output, it will not be possible to output again until the displayed value
is within output inhibition range (F-32)
2: Manual print
When [PRINT] is pressed with the MD mark illuminated, weighing data is
output.
