20
7-4. Gravity acceleration correction
When the scale is first used or has been moved to a different place, it should be
calibrated using a calibration weight.
But if a calibration weight is not available, the gravity acceleration correction will
compensate the scale. Change the gravity acceleration value of the scale to the value
of the area where the scale will be used. See the gravity acceleration map appended
to the end of this manual.
Gravity acceleration correction is not required when the scale is calibrated
using a calibration weight at the place where the scale will be used.
1. In the weighing mode, press and hold the CAL switch
until
Cal
appears, and release the switch.
2.
Cal 0
appears.
3. Press the MODE key.
The display shows the gravity acceleration value
stored in memory.
Use the following keys to change the value.
MODE key
To select the digit to change the
value. The selected digit blinks.
RE-ZERO key To set the value of the selected
digit.
4. After setting the value, press the PRINT key.
The value is stored and
Cal 0
appears again.
5. If it is necessary to calibrate the scale using a
calibration weight, go to Step 3 of “7-1. Preparation.”
To finish the setting, press the ON/OFF key to turn
the power OFF or press the CAL switch.
To store
Set using the
relevant keys
Press and hold
the CAL switch
Release the CAL
switch
