30
10. ID NUMBER AND GLP
The ID number is used to identify the scale when Good Laboratory Practice (GLP) is
used. The following GLP data is output to an AD-8121 printer or a personal computer
using the RS-232C interface.
The results of calibration (“Calibration report”)
The results of calibration test (“Calibration test report”)
The “Start block” and “End block” for GLP data
10-1. Setting the ID number
1. With the power turned OFF, press and hold the
RE-ZERO key and press the ON/OFF key to turn
the power ON and enter the function setting mode.
func
appears.
2. Press the MODE key several times to display
id
.
3. Press the PRINT key.
Enter the ID number using the following keys.
MODE key
To select the digit to change the
value. The selected digit blinks.
RE-ZERO key
To change the value of the selected
digit. See the table below for the
“Display character set.”
4. Press the PRINT key to store the settings.
func
appears after
end
.
5. Press the ON/OFF key to turn the power OFF or
press the RE-ZERO key.
Display character set
0 1 2 3 4 5 6 7 8 9 - A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
0 1 2 3 4 5 6 7 8 9 - a b C d e f g H i j k l m n o p q r s t U v w x y z
“ ” : Space
Set using the
relevant keys
Press several times
To store
