54
12-4. OP-05 Remote Scale Interface
12-4. OP-05 Remote Scale Interface
12-4. OP-05 Remote Scale Interface
12-4. OP-05 Remote Scale Interface
A two-scale system using the FC-
i
scales is possible by installing OP-05 and
connecting a remote scale. You can use any load cell platform that meets the
conditions in this section.
OP-05 Installation
OP-05 Installation
OP-05 Installation
OP-05 Installation
1. Disconnect the AC adapter from the scale.
2. Remove the two screws and panel
covering the Remote scale slot.
3. Connect the connector in the FC-
i
scales to
the OP-05 unit.
4. Secure the OP-05 unit using the screws
removed in the step 2 above.
q
If you are not using the remote scale for the moment, attach the protective screw cap
to the remote scale connector.
Notes on Using
Notes on Using
Notes on Using
Notes on Using the
the
the
the Remote Scale
Remote Scale
Remote Scale
Remote Scale
q
To get a highly accurate counting unit weight, use the main scale to register unit
weight and use ACAI feature. After registration, switch to the remote scale to count.
q
If
f-01-03
f-01-03
f-01-03
f-01-03
is set at “
1
11
1
”, then the scale will automatically switch to the remote scale
after unit weight (by sample pieces) is registered by the main scale.
Pressing the
SAMPLE
key will always return to the main scale.
q
Be aware that both the main and remote scales have separate tare values. So, if you
want to use a tare container on both, it must be tared on both.
q
F-Function
f-01-06
f-01-06
f-01-06
f-01-06
can be set so the remote scale has an independent unit weight,
or is restricted to the same as the main scale.
Specifications for Remote Scale
Specifications for Remote Scale
Specifications for Remote Scale
Specifications for Remote Scale
The FC-
i
scales has the ability of driving up to 4 load cells (350
Ω
) in a remote scale
(platform). Set for the capacity range 0.5kg to 5,000kg (1 lb to 10,000 lb).
q
The FC-
i
scales has the ability of driving up to 4 load cells (350
Ω
) in a remote scale
(platform).
q
Capacity range
for the remote scale is 0.5kg to 5,000kg (1 lb to 10,000 lb).
q
Minimum output
at zero point is 1mV.
q
Maximum output
at full load is 14mV.
Excitation Voltage of the scale is 5V.
q
Cable length
should be kept under 5m (16.5 ft.) for higher accuracy.
q
Pin connection
(JM:NJC-207-PF):
Remote scale slot
Summary of Contents for FC-50Ki
Page 1: ...Counting Scale FC 50Ki FC 20Ki FC 10Ki FC 5000i WM PD4000541...
Page 62: ...60 World map...
Page 63: ......
Page 64: ......
