12
3-5 Display Symbols and Key Operation
Key operation
Key operation affects how the balance functions. The basic key operations are:
“Press and release the key immediately” or “Press the key”
= normal key operation during measurement.
“Press and hold the key”.
Display symbols
Each key, when pressed or when pressed and held, functions as follows:
Key
When pressed
When pressed and held
Turns the display on or off. The standby indicator is displayed when the display is turned off. The
weighing mode is enabled when the display is turned on.
This key is available anytime. Pressing the key during operation will interrupt the operation and
turn the display off.
In the weighing mode, turns the minimum
weighing value on or off.
In the counting or percent mode, enters the
sample storing mode.
Enters the function table mode.
Refer to “9. FUNCTION TABLE”.
Switches the weighing units stored in the function
table. Refer to “4. WEIGHING UNITS”.
Enters the response adjustment mode.
Cancels the operation when performing settings.
Enters the calibration mode.
Outputs the weight data to a printer or personal
computer using the RS-232C serial interface,
depending on the function table settings.
Confirms the operation when performing settings.
No function at the factory setting
By changing the function table:
Outputs “Title block” and “End block” for
GLP report.
Sets the display to zero.
Number of statistical data (Statistical calculation mode)
Displays the weight data relative to the weighing capacity,
in percentage, in the weighing mode
(Capacity indicator)
Response indicators
Animal mode indicator
Comparator indicators
Units
Interval output mode
Standby indicator
Weight data
Interal output mode
Active indicator
NET indicator
Processing indicator
Stabilization indicator
Standby indicator
Processing indicator
Blinking
