FR
16
4. Étalonnage
4-1. Étalonnage à l'aide de la masse interne
(Étalonnage à une touche, uniquement séries FZ
-
i
/ FZ
-
i
WP /
FZ
-
GD)
Cette fonction étalonne la balance à l'aide de la masse interne.
1. Raccorder l'adaptateur CA et laisser la balance chauffer pendant au moins 30 minutes, plateau de
pesage vide.
2. Placer l'accessoire coupe-brise sur la balance et appuyer sur la touche
. La balance affiche
.
3. La balance procède à un étalonnage à l'aide de la masse interne. Éviter d'exposer la balance à des
vibrations ou des courants d'air.
4. Après l'étalonnage, si le paramètre « GLP output (
) » (exportation GLP) de la table de fonctions
est réglé, la balance exporte un rapport du réglage de la sensibilité.
5. La balance retourne automatiquement en mode de pesage après l'étalonnage.
Summary of Contents for FZ-i Series
