1WMPD4003552A
GP-16 The Printer Support for the AD-8127 Instruction Manual
The printer support is used to install the AD
-
8127 to GX-L/GF-L series and GP series balances made by A&D
Company, Limited.
Applicable products:
GX-L/GF-L series, GP series
Installing the printer and printer support
Step 1 Remove two screws on right side of the display case.
Step 2 GX-L/GF-L series
Remove the terminal cover for the RS-232C
interface (D-Sub 9 pin).
GP series
Remove the option cover and the rubber cover.
Step 3 Install the printer support beside the display
unit using screws (M4x15W SEMS screws).
Step 4 Place the printer (AD
-
8127) on the printer
support while holding open the hook.
Step 5 GX-L/GF-L series
Connect the RS-232C cable (AX-KO2741-100).
Connect its RS-232C connector to the display
unit and to the printer.
GP series
Connect the RS
-
232C cable (AX
-
KO2116
-
090).
Connect its 25 pin connector to the display unit
and its 9 pin connector to printer.
Step 6 Adjust the length of the remaining cable.
Bundle up cables using cable clamps
beside the display arm.
Step 7 Attach AC adaptor cables to the balance and
printer, and bundle them using cable clamps.
Caution
If the RS-232C interface terminal cover is removed from
GX-L/GF-L series, or if the option cover and rubber cover
are removed from GP series, the balance and printer
will not be waterproof and dustproof.
Packing Contents
Component parts
Quantity
GP-16 Printer support for the AD
-
8127
1
Cable clamp
2
M4 x 15W SEMS screws
2
Instruction manual (This document)
1
Step 1
Nylon M4
x
8 screws
Attach the printer (AD
-
8127)
using the hook.
Step 2
GP
display unit
GX-L/GF-L
display unit
Rubber cover
Option cover
Printer (AD
-
8127)
Step 3
Accessory M4
x
15W SEMS screws
Step 6
Hook
Printer support
Display arm
Step 7
Step 5
Connector
Step 5
Step 4
Step 4
AC adapter cable for the printer
AC adapter cable for the balance
Example of the
clamping cable
Two cable clamps
are included each
for the balance
and the printer.
Step 2
Terminal cover
Step 1
Nylon M4 x 10 screws