-16-
Entering the water temperature (
ldin 0
)
In the density mode, press and hold the MODE key until the water temperature currently
set (unit:
°
C, factory setting : 25
°
C) is displayed. Use the following keys to change the
value.
RE-ZERO key
To increase the temperature by one degree. (0-99)
MODE key
To decrease the temperature by one degree. (0-99)
PRINT key
To store the change, display
end
and return to the density
mode.
CAL key
To cancel the change and return to the density mode.
The relation between the water temperature and density is shown below.
Entering the density directly (
ldin 1
)
In the density mode, press and hold the MODE key until the density currently set
(unit : g / cm
3
, factory setting : 1.000g / cm
3
) is displayed. Use the following keys to change
the value.
RE-ZERO key
To set the value of the digit selected.
SAMPLE key
To select the digit to change the value.
PRINT key
To store the change, display
end
and return to the density
mode.
CAL key
To cancel the change and return to the density mode.
Note
The range to set the density is 0.0000 to 1.9999 g / cm3
Summary of Contents for GX-13
Page 5: ...3 1 The Kit Includes...
