A&D HL-WP Series, Instruction Manual

3

PREPARATION 

Installing Batteries / Connecting The AC adapter

Installing Batteries 

CAUTION 

When replacing batteries, be careful 
not to apply too much force to the 
weighing pan. An excessive force 
could damage the scale. 

Remove the battery cover and insert six 
batteries (R6P / LR6 / AA size) into the 
battery compartment, taking extreme 
care to that the polarities plus and minus 
are observed. Be sure to lock the 
battery cover again after installing the 
batteries. 

AC adapter (optional) 

CAUTION 

When using an AC adapter, the scale 
does not comply with the IP65. 

 
The AC input requirement could be 100, 
120, 220, 230 or 240 volts (50/60Hz) 
depending on the area where used, so 
please verify that the adapter is correct. 

Plug the AC adapter to the AC adapter 
socket inside the battery compartment. 

Attach the battery cover and fit the 
rubber cap. 

Setting up the HL-WP

CAUTION 

Avoid installing the scale in direct sunlight, as that may cause discoloration 
or a malfunction. Place your HL-WP on a firm weighing table so that the 
scale is level. (The scale will not perform accurately when it is not level.) 

Place the scale on the firm surface and adjust the feet so that the sprit level 
shows the scale is level for an accurate weighing. 

New six batteries (R6P/ LR6/ AA size)

Optional AC Adapter 

AC Adapter jack

Close the rubber cap 

Battery cover lock