4
WEIGHING
Before weighing
Automatic Power-Off Function
If the scale is left ON and the stable indicator is displayed, the automatic
power-off function turns the power off after approximately 5 minutes
(factory setting). To toggle the function disabled/enabled, press the
[ON/OFF] key while pressing the [RE-ZERO] key. The scale stores the
setting and it will be shown by pressing both the [RE-ZERO] and
[UNITS] keys in the weighing mode. (See “CALIBRATION” about the
[UNITS] key.)
poff0
e
Function disabled.
poff1
e
Function enabled.
Error message
ee
e
ee
Overload
-----
The scale zero is out of range
ea
lb
a
Low battery
Calibration may be required before weighing
Read “CALIBRATION” first and if necessary, calibrate your scale for
accurate weighing.
Weighing procedures
1. Turn on the scale.
Press the [ON/OFF] key to turn on the scale. Then the scale displays all
segments for a few seconds and then
0
will be displayed.
2. Start weighing
If you do not use a container for weighing,
Verify the reading is
0
. If not, press the [RE-ZERO] key to display
0
. Place objects on the weighing platform to weigh. When the reading
becomes stable, the stable indicator is displayed.
If you use a container for weighing,
Place an empty container on the platform.
Wait for the stability indicator to be displayed and press the [RE-ZERO]
key. Place the objects to be weighed in the container.
Select the weighing unit, --- Only for U.S.A. models ---
If you use the U.S.A. model, press the [UNITS] key to select weighing unit.
Normally scales power up in “lb” or “oz” when shipped from the factory.
To
power up in other units
, turn the scale off. Press and hold the [UNITS] key,
then press the [ON/OFF].key The scale will start with the next unit.
Note) HL-300WP: oz
Æ
g
Æ
oz
Æ
HL-1000WP/3000WP/3000LWP:
lb
Æ
oz
Æ
lb-oz
Æ
g
Æ
lb
Æ
Summary of Contents for HL-WP Series
Page 9: ...8 World Map...
